 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Power Amplifier Product Features * Small size by using simple matching circuit board * Single Supply Voltage * Heat sink 99.9% copper, gold plated * High Productivity * Low Manufacturing Cost * GaAs HFET RFT2140-08 Application * UMTS Repeater * RF Sub-Systems * Base Station Package : DP-56 Description The power amplifier module is designed for base stations and cell extenders and operating frequency range is from 1.9GHz to 3.5GHz GaAs HFET is used and attached on a copper sub carrier. It is connected by using bias and in/out matching circuit method with gold wire bonding. The bias and matching circuit are designed much simpler than other circuits for silicon IC's, LDMOS because GaAs HFET is operated by low supply voltage whereas others are operated by high supply voltage. For better thermal conductivity, enhanced mode PCB was used in the 99.9% copper gold plate heat sink. This simplicity results cost competitiveness and performance enhancement. Specifications PARAMETER Frequency Range (MHz) Small Signal Gain (dB) Gain Flatness (Max.) Intput Return Loss Output P1dB W-CDMA Power (1 FA) Output IP3 Noise Figure (Typ.) Drain Voltage Drain Current Operating mm Dimensions inTemp Range Dimensions (WxLxH) NOTE *Test condition: 2140MHz, 3GPP W-CDMA signal modulation Test Model 1, 64DPCH, 3.84MHz BW, 5MHz offset * RFT Series : Internally Matched Module RFT2140-08 2110 ~ 2170 26 1dB @ 50MHz BW -10dB 38 dBm 30dBm @ -45dBc ACLR 51dBm @ tone / 25dBm 4 dB 9V 1.5A -20C ~ +70C Functional Diagram 32.0 x 44.0 x 10.0 [mm] Tel : 82-31-250-5011 rfsales@rfhic.com All specifications may change without notice. Version 1.0 Power Amplifier RFT2140-08 Performance Charts (Vd=9V, Id=1.5A, T=25) Tel : 82-31-250-5011 rfsales@rfhic.com All specifications may change without notice. Version 1.0 Power Amplifier Package Dimensions (Type: DP-56) RFT2140-08 Pin NO 1 2 3 Function GND RF IN E/N Pin NO 6 5 4 Function Vcc RF OUT GND Installation Guideline It can be easily removed with solder wick and other removable material RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC's liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. Tel : 82-31-250-5011 rfsales@rfhic.com All specifications may change without notice. Version 1.0 |
Price & Availability of RFT2140-08
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |